2003/11/28
DIP SWITCHES SETTING
BL-700-USD4 U.S. CURRENCY BILL ACCEPTOR
1 Pulse / US $1
OFF
OFF
OFF
2 Pulse / US $1
OFF
OFF
ON
INTERNATIONAL CURRENCY TECHNOLOGIES
3 Pulse / US $1
OFF
ON
OFF
4 pulse / US $1
OFF
ON
ON
5 Pulse / US $1
ON
OFF
OFF
10 Pulse / US $1
ON
OFF
ON
20 Pulse / US $1
ON
ON
OFF
100 Pulse / US $1
ON
ON
ON
General Specifications ed bill
U.S. $ 1, 5, 10, 20, (old5, 10, 20), (new20) 4 bills.
Bill insertion Acceptance rate
4 way.
Fast output Pulse
Lo= 50ms Hi=1 00ms
ON
90% or more.
Slow output Pulse
Lo= 50ms Hi=3 00ms
OFF
The second acceptance is included in the acceptance count. The following bills are excluded.
Inhibit level Active Low
ON
Inhibit level Active High
OFF
a. Incomplete bills such as extremely dirty, wetted, Broken or wrinkled ones. b. Bills folded at a corner or side. c. Incorrect-made bills. Validation time
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8 SW9 SW10
FUNCTION
4 seconds or less. (This is the time for VEND signal output)
Accept US $ 1
ON
Reject US $ 1
OFF
Accept US $ 5
ON
Reject US $ 5
OFF
Accept US $10
ON
Reject US $10
OFF
Interface logic
Photo coupler isolation signals (input). Transistor control signals (output).
Accept US $20
ON
Maintenance
Can be opened at upper.
Reject US $20
OFF
(A hinge is attached at the back) Power
DC+12V + 5%.
Power consumption
Standby : 0.11A @ DC+12V Operating : 1.5~2.0A @ DC+12V
High Security With Antifish Function High Acceptor Without Antifish Function
ON OFF
Manufacture setting
Note: After setting dip switch of the credit pulses , you should reset the bill acceptor again.
Environment
Installation
Operating : 0 C 45 C. Storage : -20 C 60 C. Humidity : 30% - 85% RH.(not-condensing) In-house.
-1-
Antifish function is limited only to the BA without stacker.
BILL
ACCEPTOR Weight : 700g
PLASTIC STACKER P2 Weight : 1500g (200pieces) P6 Weight : 1600g (600pieces)
-2-
CONNECTOR (600H, 700A, 700C STD) 1 2 3 4 5 6
-------
POWER DC+12V+5% ...............................(RED) POWER GND ....................................(ORANGE) INHIBIT INPUT (+5~12Vdc).................(YELLOW) INHIBIT GND .........................................(GREEN) VEND+; CREDIT PULSES OUTPUT ........(BLUE) VEND- ; CREDIT PULSES OUTPUT ...(PURPLE)
Credit Pulses Output Interface: +5V
6
VEND+
7.
VEND-
8.
R
5
4
3
2
U
1 BILL ACCEPTOR
GREEN.......... INH-(2) BLUE............. VEND+(7) PURPLE........ VEND-(8)
Inhibit Signal Input Interface: +5V ~ +12V
6 9
2 5 8
4 7
1 4 7
2 5 8
PHOTO COUPLER PC 817 EQUIVALENT
INHIBIT IN
3
IN
6
INHIBIT
9
2. BILL ACCEPTOR
LESS THAN 1V
Inhibit level:
Dimensions: 168.6
28.5
80
Inhibited B.A.
78.4 166.5 (600 pieces)
Unit: mm
BILL
ACCEPTOR
78.4
Unit: mm
P6
PLASTIC STACKER
7.5
7.5
Actived. (No Voltage to Inhibit lines.)
256.0
256.0 81.5
Active High : Inhibited B.A. (Added Voltage "5~12Vdc" to Inhibit lines.)
80.2
3.3
40
134.0
Inhibited B.A.
134
Actived.(When added voltage "5~12Vdc" to Inhibit lines.)
93.0
17.5
93
Inhibited B.A. (No Voltage to Inhibit lines.)
139.6
80.1
3.3
134.0
93.0
74.1
Active Low :
73.6
3
1
17.5
RED............... 12V(5) ORANGE....... GND(9) YELLOW........ INH+(1)
137.5 (200 pieces)
Unit: mm
P2
PLASTIC STACKER
2003 International Currency Technologies Corporation Vol. 4.0 Part Number H4358C
-3-
-4-