Jsa For Using Jack Hammer 6m6x10

Job Safety Analysis (JSA) VDU Revamp Project COMPANY:

SENDAN/ RIYAN GULF

DATE:

JSA NO:

(SUB-CON’)

EQUIPMENT/ TOOLS USED:. Air Compressor, Jackhammer

WORK: Removing of Concrete by using Jackhammer NAME

PREPARED BY: CONSTRUCTION

POSITION

Furqan Ahmad Nazir Ahmad

REVIEW BY: HSE

SIGNATURE

Project Engineer HSE Supervisor

Activity Order

Potential Hazards

Risk Rating

Hazard Control Proactive Measures

Risk Rating

List the steps required to perform the task in the sequence they are carried out.

Against each step list the potential hazards that could cause injury when the task is performed

L/M/H

For each hazard identified list the control measures required to eliminate or minimise the risk of injury.

L/M/H



Maintain equipment

 

Equipment damage or failure Personal injury

M

   



Set up Equipment

Sul-123.REV-0

 

 Equipment damage Slips, trips, falls

M

 

Complete Daily Equipment Checklist. Familiarize yourself with Operators Manual Familiarize yourself with instructions on compressor All personnel in this area must have on hearing protection Check overall condition of compressor and jackhammer Check oil and fuel levels. Check all fittings and hose connections, if hose is worn or connections and/or bands on hoses appear suspect-remove and replace immediately, when not in use store hoses off of the ground VDU Revamp SPC 2845

L

L

Page 1 of 3

Job Safety Analysis (JSA)  

 





Running compressor

Fuelling compressor

Sul-123.REV-0

     

Equipment damage Fire hazard Slips, trips, falls Improper clothing Personnel burn while refuelling compressor Dust or organic vapours

  

Fire hazard Spill Eye injury from splash

   M     M

Choose level area to set up compressor, chock wheels. Ensure that hose whiplash arrestor are on both the compressor end and the jackhammer end, tighten loops to avoid slippage, use cotter pins or tie wire at Chicago fittings to positively lock connections Make sure hose is out of the walking/working area minimizing trip hazards. Inspect and barricade area with warning signage around compressor for any tools/objects that may pose a tripping hazard Check the fuel level in compressor Set compressor to appropriate pressure for use. Be aware of anything that may get hot or burn around compressor. Have proper size and type of fire extinguisher within 15 feet of work area with trained fire watchman. Remove any flammable items from work area. Allow compressor time to cool down before fuelling, at least 5 minutes When stopping, some compressors may need to go through cooling cycle. Read instructions on side of compressor to determine if it requires cooling cycle, release any stored air in compressor when done for the day and before disconnecting hoses, keep valve closed when connecting/disconnecting VDU Revamp SPC 2845

L

L

Page 2 of 3

Job Safety Analysis (JSA)  



  

End of task

Slips, trips, falls Traffic hazards Pinch points

    

M

hoses Fire extinguisher within 15 feet of refuelling. Use spill rag to catch any overspill of diesel or kerosene. Maintain clear travel paths Pick up all tools, materials, and debris. Ensure work area is secure Return all tools to proper location. Dispose of all debris in proper container.

ADDITIONAL HAZARDS IDENTIFIED   

CONTROL MEASURES

 

Workers unaware of job hazards No Proper supervision Working without Permit



SULZER CONSTRUCTION DEPARTMENT

DATE:

Toolbox talk must be conducted prior to start task. Construction supervisor & HSE inspector shall be available at site. Valid Work permit must be obtain prior to start job. SENT FOR REVIEW

APPROVED NAME

L

POSITION

SIGNATURE

HSE. DEPARTMENT

Sul-123.REV-0

VDU Revamp SPC 2845

Page 3 of 3