Format For Mini Project 5k576g

TITLE OF THE PROJECT (Title: Times new roman centered bold font size 16 and capitals) An industry-oriented Mini-Project submitted in partial fulfillment of the requirements for the award of (text size 12 and centered) Degree of (text size 12 and centered) Bachelor of Technology (text size 12 bold and centered) in (text size 12 and centered) Mechanical Engineering (text size 12 bold and centered) By (text size 12 and centered)

NAME OF THE STUDENT

ROLL NUMBER (text size 12, capital and centered)

Under the Guidance of (text size 12 and centered) NAME OF THE FACULTY (text size 12, capital and centered) DESIGNATION IN FULL (text size 12 capital and centered)

(image centered size height 1.5” X width 1.46”)

Department of Mechanical Engineering (text size 12, bold and centered) Swami Vivekananda Institute of Technology (text size 12, bold and centered) (d to JNTUH, Approved by AICTE) (text size 12, bold and centered) Mahbub College Campus, Secunderabad – 500003 (text size 12, bold and centered) 2012 – 2016 (text size 12, bold and centered) (Remove space between paragraph above 5 lines)

SWAMI VIVEKANANDA INSTITUTE OF TECHNOLOGY Mahbub College Campus, Secunderabad 500 003. Department of Mechanical Engineering

CERTIFICATE This

is

to

certify

that

the

mini

project

entitled

…………………………………..…………………………………..……………………………….. that is being submitted by Sri / Ms………………………………………. in partial fulfillment for the award of B. Tech in ………………………….. to the Jawaharlal Nehru Technological University is a record of bonafide work carried out by him / her under our guidance and supervision. The results embodied in this mini project have not been submitted to any other University or Institute for the award of any degree or diploma.

Supervisor

Professor & Head

External Examiner

ii

Principal

Acknowledgement

iii

Contents (text size 12 bold and left aligned) The following is suggested format for arranging the Dissertation / Thesis matter into various chapters. Chapter Name

Page no. (text size 12 and

1

Introduction

1

2

Chapter Two

10

Chapter no. bold)

… (follow above format as it is)

iv

List of Figures (text size 12 bold and left aligned) Page no. 10

Figure Number

Figure Name (text size 12)

1

Xyz

… (follow above format as it is)

The arrangement of paragraph in a Chapter : Each topic Title in a chapter should be properly numbered for example: 2.1, 2.2. etc., (Bold and Upper case) where, the first digit represents the Chapter number, and second digit, the topic Title number. Sub-topic titles, if any, may be indicated as 1.1.1, 1.1.2, etc. (Bold and title case) i.e. the first digit representing the chapter, the second representing the topic title and the third representing the sub-topic title. Photographs and Tables: The photographs and tables occurring in a chapter may be serially numbered as Fig: 1.1, 1.2 etc., along with suitable CAPTION where the first digit represents the chapter, the second digit represents figure number. The photograph may be represented as: plate 1.1, 1.2 etc., the first digit representing and the second representing the photograph number.

chapter

Graphs : The graph should clearly indicate the points which are used for drawing the curve or curves along with the error bars. The axes (X, Y and Z) should have CAPTIONS. Bibliography or References: The following format may be used for the Bibliography / References: For Book Sl. No

Author (s)

Book

Publisher

Year

Pages (PP)

Year

Pages (PP)

For Journal / Proceedings Sl. No

Author (s)

Paper

Journal

Vol. No, v