Aquastain - Masonry Coating 1y4e6y

Material Safety Data Sheet EMERGENCY PHONE: CHEMTREC 1-800-424-9300 INFORMATION PHONE: 1 – 800 – 862 - 2667

I. CHEMICAL PRODUCT AND COMPANY DATA PRODUCT:

AQUASTAIN T-96

CHEMICAL FAMILY:

MASONRY COATING

REVISION DATE:

3/02

MANUFACTURER:

TAMMS INDUSTRIES 3835 State Route 72 Kirkland, Illinois 60146

II. COMPOSITION / INFORMATION ON INGREDIENTS This document is prepared pursuant to the OSHA Hazard Communication Standard (29 CFR 1910.1200). EXPOSURE LIMITS INGREDIENT

CAS. NO.

TLV

STEL

PEL

CONTENT

ACRYLIC COPOLYMER

N/A

N/E

N/E

N/E

<40%

TITANIUM DIOXIDE

13463-67-7

N/E

14808-60-7

>10%

ETHYLENE GLYCOL

107-21-1

50ppm

N/E

5 mg/m3 (respirable) 10 mg/m3 (respirable) 50 ppm

<25%

CRYSTALLINE SILICA

5mg/m3 (respirable) .1mg/m3

AMMONIUM HYDROXIDE

1336-21-6

50 ppm

N/E

50 ppm

<1%

N/A : Not available

N/E

<2%

N/E : Not established

III. HAZARDS IDENTIFICATION HMIS Hazard Rating No. 2 (Moderate) PRIMARY ROUTE OF ENTRY: INHALATION, DERMAL, EYES EFFECTS OF OVER EXPOSURE: INHALATION: EYES: SKIN : SKIN ABSORPTION:

Vapors from product may cause irritation to the nose, throat, and respiratory tract. Direct can cause slight irritation. Prolonged or repeated skin can cause slight skin irritation. No known information available.

INGESTION:

Not expected to be relevant route of exposure.

CHRONIC:

Repeated exposure may cause skin irritation.

Aquastain T96 MSDS Page 1 of 4

IV. FIRST AID MEASURES INHALATION: EYES: SKIN: INGESTION:

Remove victim from exposure to fresh air. Seek medical attention. Flush eyes with water, lifting upper and lower lids occasionally for 15 minutes. Seek medical attention. Wash thoroughly with soap and water. Seek medical attention if irritation persists. Do not induce vomiting, but drink plenty of water. Seek medical attention for discomfort.

V. FIRE FIGHTING METHODS HMIS Hazard Rating No. 0 Flash Point: Non Combustible

METHOD: SETAFLASH

AUTO-IGNITION TEMP.: None LIMITS OF FLAMMABILITY: Not combustible EXTINGUISHING MEDIA: Use water for, dry chemical, foam or CO2. SPECIAL FIRE FIGHTING PROEDURES AND PRECAUTIONS: Do not enter confined fire space without full bunker gear (helmet with face shield, bunker coats, gloves and rubber boots), including a positive pressure NIOSH approved self contained breathing apparatus. Cool fire exposed containers with water. UNUSUAL FIRE AND EXPLOSION HAZARDS: Containers exposed to intense heat from fires should be cooled with water to prevent pressure build up, which could result in container rupture.

VI. ACCIDENTAL RELEASE MEASURES ACTION TO TAKE FOR SPILLS/ LEAKS: Dike and contain the spill. Soak up residue with an absorbent such as clay, sand or other suitable material. Keep run-off and spills out of sewers and bodies of water. Dispose of absorbent material in accordance with Federal, State and local regulations. WASTE DISPOSAL METHOD: Dispose of in accordance with federal, state and local regulations.

VII. HANDLING AND STORAGE Store at temperatures 33° F to 100°F

Store in ventillated area.

KEEP FROM FREEZING

VIII. EXPOSURE CONTROLS/PERSONAL PROTECTION PERSONAL PROTECTION RESPIRATORY: Under normal conditions none required. Wear a NIOSH approved respirator if standards are expected to be exceeded above exposure limits. EYE: Chemical tight goggles or safety glasses with side sheilds.. SKIN: Use rubber gloves and protective clothing to prevent skin .

ENVIRONMENTAL CONTROLS Use exhaust ventilation to maintain vapors below exposure limits.

Aquastain T96 MSDS Page 2 of 4

IX. Physical And Chemical Properties Boiling Point: Percent Volatile: Freezing Point : Vapor Pressure mmHg @ 20o C Vapor Density Odor Threshold: Appearance: N/AV = Not Available

212 F NONE, SOLID NONE, SOLID 17 mm Hg @ 20C >AIR N/A Liquid

Water/Oil Distribution Coefficient: Solubility in Water: Specific Gravity: pH: Evaporation Rate:

N/A YES 1 – 1.2 9 – 10 <water

Odor:

Slight ammonical

ca. = Approximate

X. STABILITY AND REACTIVITY HMIS Hazard Rating No. 0 STABILITY: Product is stable. CONDITIONS AND MATERIALS TO AVOID: Contamination with strong acids or base. HAZARDOUS DECOMPOSITION PRODUCTS: Carbon Monoxide, Carbon Dioxide

XI. TOXICITY INFORMATION HMIS Hazard Rating No. 1 (SLIGHT) PRIMARY ROUTE OF ENTRY: INHALATION, DERMAL, EYES EFFECTS OF OVEREXPOSURE INHALATION:

May cause irritation to nose, lung and respiratory tract.

EYES:

May cause eye irritation. The aggregate particles may cause corneal abrasions. May cause dry skin, irritation, and alkaline burns. No information available.

SKIN : SKIN ABSORPTION: INGESTION:

CHRONIC:

Not expected to be relevant route of entry. Ethylene Glycol causes kidney damage. Symptoms may include abdominal discomfort and pain, lumbar pain CNS depression related to ethylene glycol ingestion. Severe kidney damage accompanies gross overexposure. Respirable crystaline silica is a suspected cancer agent by NTP and IARC. This product contains silicon dioxide and titanium dioxide as the filler, which are bound in the resin matrix, hence affects of any exposure to inhalation as nuissance dust is unlikely..

XII. ECOLOGICAL INFORMATION Marine Pollutant: NL (NL = Not Listed; P = Moderate; PP = Severe; ND = Not Determined)

XIII. DISPOSAL CONSIDERATIONS Dispose in a manner which is compliant to Federal, State and Local regulations. Aquastain T96 MSDS Page 3 of 4

XIV. TRANSPORT INFORMATION DOT/UN SHIPPING NAME: NON-REGULATED DOT HAZARD CLASS: NON-REGULATED SHIPPING NAME: NON-REGULATED

Emergency Response Guide: 128

XV. REGULATORY INFORMATION COMPONENTS ARE LISTED ON THE EPA/TSCA TITLE III SECTION 302: TITLE III SECTION 311/312: TITLE III SECTION 313:

INVENTORY OF CHEMICAL SUBSTANCES No reportable materials. No reportable materials. Ethylene Glycol (107-21-1)

CALIFORNIA PROPOSITION 65

Crystalline Silica (14808-60-7) is considered to be a carcinogen by the state of California.

XVI. OTHER INFORMATION Information contained in this MSDS refers only to the specific material designated and does not relate to any process or to use with any other materials. This information is based on data believed to be reliable as of the date hereof. It is furnished without warranty of any kind express or implied. Since actual use is beyond our control, no guarantee, express or implied, and no liability is assumed by TAMMS INDUSTRIES in conjunction with the use of this information. Nothing herein is to be construed as a recommendation to infringe any patents.

Aquastain T96 MSDS Page 4 of 4