A Business Card Holder 5i3h1d

A Business Card holder By Melissa Davies for Swap Sisters

Supplies you will need:

• • • • • • • • • •

Big Shot machine Top note die 10 cm x 13 cm cardstock for top note die 15.5 x 7.5cm coordinating cardstock for front part of holder Bone folder Scoring blade Sticky strip 1” round circle punch Oval scallop punch Oval punch

Step 1 Run your 10cm x 13 cm cardstock through the big shot using the top note die

Score along the 13 cm side of your top note die 2.2 cm from the point at the bottom as shown above.

Step 2 Cut your other piece of cardstock to 15.5 cm x 7.5 cm. • •

On the 7.5 cm sides score in at 1 cm and 2.5 cm on both sides At the 15.5 cm side and ON ONE SIDE ONLY score at 1.5 cm

Step 3 On the 7.5 cm side where the score line is at 1cm cut the corner off to the 1.5cm horizontal score line. Do this on both sides.

Cut the score line at the 2.5 cm score line to the 1.5 cm horizontal score line

Step 4

Use your circle punch to cut the half whole at the top of the cardstock as seen in the above photo

Step 5 Attach sticky strip as shown in the photo below

Step 6. Peel off sticky strip on your two small tabs first on the side at the bottom Form your basic box shape Then peel of remaining sticky strip and adhere to your top note as per picture below;

Step 7 Embellish as desired, then add your business cards

And you are finished. Thanks

Melissa